Cotton Voile fabric detailed introduction

Cotton Voile is a thin and transparent fabric woven with a flat line. It is characterized by the latitude and latitude. The latitude and latitude use the fine combed strong twisting yarn. The latitude and longitude density in the fabric is relatively small. Due to "fine" and "thin", plus strong twisted, the fabric is thin and transparent. The raw materials used are cotton and polyester.

The latitude and weft yarn in the fabric, either a single gauze, or the stock line. Different processing, Cotton Voile has dyed VOILE, bleached Voile, print VOILE, and savanxe flower VOILE, etc. The "texture of the VOILE fabric is thin, the feel is cool, the fabric is clear, and the fabric is transparent and breathable.

The most common are 60*60/90*88 and 60*60/70*70 and other specifications. Simple fabrics are also easy to produce quality problems. The most common problems are:

1: Poor strength of the strength

2: The color is not allowed to be dark

3: There are holes in the cloth surface

4: There are a lot of hairy feathers on the fluffy surface

5: black eyes on the cloth

6: The shrinkage rate is not good

To avoid the above problems, the gray fabric is also the key. The grain cloth has general comb, semi -precision comb, combed, divided from the weaving machine, is made of jet, the sword is made, there is a shuttle, and the door is not consistent. Inch, 63 inches, 64 inches, 67 inches, some of the latitude and longitude density are not enough, the price is very different, the cheapest is about 4 yuan, only pocket cloth, the most expensive one is more than 6 yuan.

There are many causes of problems in the production process of printing and dyeing.

1. The speed of burning hair is generally good. Some factories think that this thin cloth is to be burned and the result is very hairy.

2. Remind the former fabric to do a strong test when cooking.

3. In the oxygen drift, the craftsman should be reminded to check the water quality. If there are many heavy metals in the water, a hole will be made on this cloth (generally the printing and dyeing factory is not paid attention to, but there is no hard matter on the machine drum. This is directly leading to the small hole). Then it is a big hole.

4. Remind the foreman when the silk is light, and the door width should not be too large. This side is easy to break. The light concentration is generally enough. The tension is as small as possible.

5. Remind the masters when dyeing, and put some sea alginic acid to prevent black eyes on the cloth surface. Follow the machine to say hello to the block, do not pass the speed, especially on the machine, the tension is easy to break. Once it is broken, immediately take the guide cloth and re -you. You cannot try it again and again.

6. This cloth is popular now, but the flower types with many holes must be embroidered with large machines.